Follow @kepco_careers
Advanced Search
Kepco Power Solutions
718-461-7000

RACK ADAPTERS

  • RACK MOUNTING SYSTEMS
    • Models RA 24 and RA 37 are for power supplies and programming interfaces.
    • Model RA 22-6A mounts Kepco Laboratory-type power supplies CC and PCX-MAT (6 plug-in slots).
    • Model RA 32 mounts CC, PCX-MAT and any one 1/2 rack or two 1/4 rack size models (3 plug-in slots).

  • RACK ADAPTERS
    • RA 19 and RA 19-1U: for mounting of HSF and HSF-1U power modules in a 19-inch rack
    • RA 55: for mounting of MST power modules and MST 488-27 interface in a 19-inch rack
    • RA 56: for mounting of DPS power supplies in a 19-inch rack
    • RA 59, RA 60: for mounting HSP in a 19- 23- or 24-inch rack (hot-swap capability)
    • RA 58, RA 61: for mounting HSP or HSM in a 19- 23- or 24-inch rack (no hot swap capability)
  • RACK ADAPTER PANELS These models adapt Kepco (linear and ferroresonant modules) power supplies to the standard 19" wide equipment rack or cabinet. Panel mounting holes are pre-drilled (standard E.I.A. pattern).

    • RA 26 through RA 28: for mounting PAT models in a 19-inch rack
    • RA 33 through RA 35: for mounting PTR models in a 19-inch rack
    • RA 8 through RA 10, RA 14 through RA 17. RA 30, RA 31, RA 38: for mounting PRM models in a 19-inch rack

CASES

Models CA 3, CA 4, and CA 5 Cases provide single, double or triple unit housings for CC or PCX-MAT models.

CONNECTORS

  • 30 and 50 terminal printed circuit edge to cable connectors, both prewired and unwired (for unique user configurations)
  • GPIB connectors for SN 488, BOP and BIT interfaces.
  • 12-terminal printed circuit edge connector to barrier strip interface
  • 12-terminal printed circuit edge to cable connector

FILLER PANELS

Filler Panels are available for the RA 24, RA 37, SNR 488

CURRENT SENSING RESISTORS

These precision, wirewound sensing resistors may be used to provide a voltage drop proportional to load current for use in providing current feedback.

MOUNTING ADAPTERS

Mounting adapters allow direct replacment of older models with newer models, compensating for different mounting hole and hardware configurations. Jost install the new supply on the mounting adapter, then install in the same location as the power supply being replaced.
TOP NEXT

Products Support Literature Contact Us Careers About

KEPCO, INC. 131-38 SANFORD AVENUE FLUSHING, NY. 11355 U.S.A.
TEL (718) 461-7000 FAX (718) 767-1102
www.kepcopower.com email: hq@kepcopower.com